When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $29.68
8.2CM 4D LED Illuminated Car Logo Decoration For BMW E36 E46 E53 E90 E60 E61 E93 E87 X1 X2 X3 X5 X6 F30 F20 F10 G30 Accessories
[Color] Red, white, blue, choose one from three[Power supply] DC12V+/- 10%[Wiring length] 0.6m[Power] 2 (W)[Voltage] 12 (V)[Current] 0.1 (A)[Tools prepared before installation]Please prepare the following tools before starting: 1. Flat head screwdriver 2. Cross head screwdriver 3. Insulating tape 4. Towel 5. Pliers[Installation Instructions]First, lay a towel next to the trunk logo, and use a flat screwdriver to pry the logo. The purpose of laying the towel is to prevent scratching the vehicle body.2. Pay attention to peeling off the double-sided adhesive tape from the vehicle body first. When prying, use moderate force and don't use too much force. Slowly pry it off bit by bit, and clean the double-sided adhesive tape on the vehicle logo and vehicle body.3. Use a cross screwdriver to remove the partition inside the boot. Note that there are clips in some places. Be careful to remove the sound insulation panel to see various lines.4. Now, install the vehicle logo lamp. The power cord of the vehicle logo lamp passes through one of the vehicle logo positioning holes, passes through the inside of the vehicle compartment, and tears off the single sided adhesive on the back of the vehicle logo lamp. While pulling the wire, stick the vehicle logo lamp to the vehicle body and press it tightly.5. The vehicle logo light is installed, and now connect to the power supply. The vehicle logo lamp should be connected to the power supply of the rear license plate illumination lamp, so that when the small night light is turned on, the vehicle logo lamp will also be turned on at the same time. Find the power connector for the rear license plate lamp.6. First unplug the plug, peel a hole at the positive and negative electrodes, expose the wire core, and connect the wire in red to red and black to black. Don't forget to wrap it with insulating tape, and finally plug the plug back in! Replace the tailgate sound insulation panel.