When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $144.99
Differential AWD Control Valve - Aztek, Rendezvous, Venture, Montana PN# 88896067
****** CONDITION ****** Stock photo shown.
You will find that theO-rings cleaned/replaced - inspected and tested- fully re-furb and will replace / refund if not working as designed.
You will receiveinstructions to test, remove and replace the old partIntended for all the DIYs out there who is willing to do the work and save MONEY !!!
Only Seller offering 90 day warranty!!!!!!!
Beware of those selling the \"AS IS\" \"No Refunds\" as this may be WASTING YOUR MONEY.Stay with those offering warranty , Free returns as I will send you a replacement.
THESE HAS BEEN tested , all o-rings replaced / CLEANED !!!!!! These are a common problem to go out and will cause your AWD light on the dash to stay on when it fails.Very rare that I come across these as AWDs are a bit scarce.
Actual part may have varying degree of surface contaminates on outside which doesn\'t affect performanceMy research indicates this will fit the following;Buick Rendezvous 2002, 2003, 2004, 2005, 2006, 2007Buick TERRAZA 4 X 4 2005, 2006Buick TERRAZA AWD 2005, 2006 Chevrolet UPLANDER 4 X 4 2005, 2006Chevrolet UPLANDER AWD 2005, 2006 Chevrolet Venture APV 2002, 2003, 2004, 2005 Oldsmobile Silhouette APV 2002, 2003, 2004Pontiac Aztek 2001, 2002, 2003, 2004, 2005Pontiac MONTANA APV 2002, 2003, 2004, 2005Pontiac MONTANA AWD SV6 2005, 2006Pontiac SV-6 4 X 4 2005, 2006 Pontiac Transport APV 2002, 2003, 2004, 2005 Saturn Relay 4 X 4 2005, 2006NOTE; When you receive this replacement either you or your mech. needs to unplug the bad one and plug this replacement in to verify your AWD disabled light goes out before doing full install.
NOTE: If your doing this work yourself , Very easy to switch out. Just two # 10mm bolts.
This part can be removed yourself saving you hundreds of $
A small flat screwdriver under the release tab and slide the cannon plug jack off the control valve plug.
Make sure ignition is OFF, and replace with the purchased valve
Start the vehicle and wait a few moments. A good replacement will show normal THE DISABLE AWD warning will not illuminate.
ONLY AFTER YOU VERIFY your disable AWD light is out then you can proceed in removing the two bolts with a 10mm socket.
Be careful on removing old valve as you will get a fluid rush. After all this work done I would suggest you replace your fluid withfactory specified Versatrak Fluid.You may want to have a bucket avail. to catch your old fluid.
Removing your old valve requires a large pair of channel locks, twisting back and forth. Sometimes a screwdriver under each flange to lossen..
Pull the valve straight out while twisting slightly. Install the new valve, bolts, harness jack and replace your fluid.
Recommended youreplace the used transfer case fluid with new factory specified Versatrak fluid.
90 day Warranty
If failure, I will pay return shipping cost and any refunds / part replacement would happen after I get purchased item back. Each Valve is inspected prior to being shipped and must be returned in the same working, clean and undamaged condition. .
FREE SHIPPINGSame day ship2-3 day FREE USPS Ground\"We try to earn 5 star ratings in all areas. If you have any problem, please contact us before leaving feedback to give us an opportunity to resolve it.We want you to be completely happy with our product and service.\"
Thanks for looking
Track Page Views With
Auctiva\'s FREE Counter