Supercharged RSX vs B series civic hatch drag race
2004 Acura Rsx Type S
9psi JRSC w/ I/RH/E kpro street tuned
vs
Civic hatch
im guessing a b18b or b18c
b18c would have ran faster than a 15.4 i think
I had a terrible launch and spun a little of 2nd. My fastest time of the day was a 13.44
428R Roush Mustang Beaten by RSX Drag Racing
This is a 428R Roushcharged Mustang, supercharged 4.6L 435hp 400 ft-lbs getting beat by an Acura RSX. I have no idea what was done to the RSX, I never got a chance to talk to the kid. From where I was standing it looked like 428 SC, but its not, I looked closer at the car its a 428R. Needless to say we were a little shocked the RSX took him down, very good drag race though.
JRSC ITR Build Up - Chapter 1
This clip shows the progression of my JRSC supercharged B18c-R DC2 Honda from it's humble beginnings as a turquoise Vti-R to how it look today.
This movie has a bit of a sad ending. Bye bye B18c-R.
Thats ok though, chapter 2 shows the re-power with a JE/Eagle forged B18c and a bit more Boost + methanol :)
Credit to Adam Plews for the initial build, my part comes later
Enjoy.
Music by Pendulum - Planet Orion
**** For all the haters of the rear bumper, this video is actually getting pretty old now, the holed bumper is long gone, now replaced by a plain 98 spec. ****
RSX FAIL -Power isn't everything
Power isnt everything in drag racing, and plenty of people like this fully built, turbo RSX owner show us exactly that. 600+ horse power K series Honda runs 13's.
Turbo RSX Type S vs Supercharged RSX Type S
My 480whp turbo RSX against a 300whp supercharged RSX
Supercharged RSX was tuned with Nitrous @ 340whp but ran out of spray midway in the 2nd run. First run he was not spraying however.
First run we started in 2nd gear, and you can hear me just spinning until I catch mid way in 3rd lol
2nd run I had him start just before me while in 3rd gear.
Final pull by me at the end was in 3rd gear as well.
2006 Rsx Type-S Final Tune at Innovative Motorworks 02.05.11
Derek making the final touches for the tune on my car!! This is defenitely not the same car I puchased 20k Miles Ago!! Its like i just swapped in a bigger, beefier engine in it!! HUGE DIFFERENCE!!! Mods are Innovative Billet Aluminum 75a Motor Mounts, Rbc Intake Manifold, Hondata Intake Gasket, Karcepts Adapter, AEM V2 Intake, Megan Racing Race Header, Buddy Club 2.5'' Catback, Innovate Wideband Air/Fuel Guage, and Revo Short Shift with Aluminum Shift Bushings!!
How To Adjust Valves Honda B18C VTEC 4 Cylinder -EricTheCarGuy
Visit me at: http://www.ericthecarguy.com/
Discussion about this video: http://www.ericthecarguy.com/component/kunena/18-The-EricTheCarGuy-Video-Forum/38065-B18C-Valve-Adjustment-Video?Itemid=0#38065
B Series Timing Belt Video: http://www.ericthecarguy.com/vmanuals/22-vmanual-store/69-hondaacura-b-series-timing-belt-vmanual
Valve adjustment tool: http://buy.snapon.com/catalog/item.asp?search=true&item_ID=635892&PartNo=YA8895&group_id=675629&supersede=&store=snapon-store&tool=all
Long feeler gauges: http://buy1.snapon.com/catalog/item.asp?P65=&tool=all&item_ID=635151&group_ID=675336&store=snapon-store&dir=catalog
VTEC explanation video: https://www.youtube.com/watch?v=nc800hkqY2M
I think this might just about complete my valve adjustment videos on Honda engines. There are only a couple more that I can think of that I haven't covered like the Vigor 5 cylinder engine and the DOHC VTEC found in the NSX (that will be a fun one trust me) but that's about it. As you can see in the video this valve adjustment requires a special tool. You don't have to use the same one that I used in the video but you won't be able to accomplish this procedure without some sort of special tool. Once again make sure the engine is cold and it's probably not a bad idea to run back through them after you go through the first time just to make sure everything is still in spec, it's strange how one revolution of the crank shaft can change things. Otherwise good luck.
Music from Apple's Soundtrack program: Bosa Long
Stay Dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
Nyce1s.com - Jay's All Motor B-Series Civic @ Englishtown!!
Here is some footage of Black Jay as he recently ran his all motor civic at Englishtown's Raceway Park.
Checkout http://www.yoparts.com for the best parts pricing online!!
Checkout http://www.nyce1s.com/forum for more automotive drag race and car show videos!!
RSX supercharged at 12 psi with aftercooler 1/4 mile
rsx with
jrsc at 12 psi with an aftercooler
bcrh
injen cai
3 inch Exhaust
1st run ever with the setup and 2nd time driving stick at the track
tires are toyo proxes 4 tires with no tread.
i went to the track to get a time before slicks and this is the only pass i got because my trans went out the 2nd pass.
