85 4runner on rocky mountain loop
Shakedown run in my 85 4Runner after a year and a half build. Specs are
22R, W 56, Marlin Ultimate Dual Crawlers clocked 10 degrees, Lock Right in
the rear and open in the front, geared 4.10. Lift comes from Superlift in
the front with stock rears with extended shackles, add a leaf and 2 inch
blocks from Auto Zone (Which I don't recommend.) Armor comes from Trail
gear for the front axle and All Pro for the sliders and a heavily massaged
Triple X cross member for the clocked cases. The axle wrap you hear my
camera man talking about started to crush the lift blocks down around the
spring perch causing the pinion to rotate up. If you look closely you can
see it. I later did one of the harder lines at Kodak Rock before the
damage was noticed. 63 inch Chevy's are in my near future.....
4Runners Off-Roading - Part 3 of 5
Four 4Runners offroading at Bridgeport OHV Park in Bridgeport, TX.
Part 1 - steep inclines
Part 2 - rocky trail and tight squeeze
Part 3 - mud and more mud
Part 4 - rocky trail and rocky incline
Part 5 - we stop to watch rock crawling jeeps
4Runner SAS Build-Up
Some pictures of my sas and buildup with a few poser shots at the end.
1990 Toyota 4Runner-22RE-5 speed-TG 3" front/4" rear-35" BFG
M/T-4.88's-rear LSD-front TruTrac-MC Rear Bumper-TG DOM Sliders-TG
Parts were from either Marlin Crawler or Trail Gear
Awesome 350 Chevy Swaped 89 Toyota 4Runner
Filmed at 4wheelparts San Antonio.
Really liked this guys set up front he 350 swap and custom headers to the
lift set up and the Exhaust. Alot of
effort went into this rigs set up on picking the right parts. When he says
he can cuz at 80 all day with that 4l60e i believe it. Diff would like
someday to get video of it in action towing the camper out back. All i can
think about now is setting up a water system in the back of my GMC jimmy
lol. Keep on rockin guys and girls hope yall like this video. For pictures
of this day please check out my facebook page.
Skull Crusher Adventures is now on FACEBOOK, video updates, and pictures
shared Weekly. http://www.facebook.com/SKULLCRUSHERADVENTURES
Filmed with a Canon 600D (T3i) Sigma 18-50mm 2.8-4.5 Lens
And Canon Sx30Is
Edited with a Sony Vegas Pro 11
Filmed and Edited by Skull Crusher Adventures All Rights Reserved
Music by: Keven Macleod
Rob's 89 Toyota Rockcrawler from 35's to 42's
These are some random clips of my Toyota pickup from Tuttle Creek (near
Randolph, KS) and down at Disney, OK. Started out with a Toyota straight
axle swap and 35" procomp xterrains... Ended up 1 ton axles (d60/14b) and
42" super swamper IROKs. Had a blast in that rig. Yes the engine was making
a loud clatter but kept chuggin' away. The guy I sold the motor to called
to let me know the cam was wore so much and that's why we could never get
the valves adjusted right. Front springs was a home brew toy rear pack, 63"
chevy rears. Running a 2.28+4.7 doubler with twin stick.
Updates and Fixing up the 1987 Toyota 4Runner
I've been working on the Runner a lot recently. I've gotten a lot of things
done on it but there is still quite a bit more to do. My main focus for the
near future is a brake upgrade. Building a motor and a total restoration of
the body are a couple years away.
2004 Toyota 4Runner Transmission Fluid and Filter Change (Part 1) -EricTheCarGuy
Visit me at: http://www.ericthecarguy.com/
Discussion about this video:
To be honest if I were to do this job again I would just change the fluid
and leave the filter alone. It's much less of a headache and you won't
have to worry about the Exhaust which
would be the most challenging part in my opinion. Aside from that it's not
likely a filter change will have any real benefit since it's a closed
system. In addition there is some speculation as to what the service
interval actually is for the transmission fluid and filter is. Lastly be
sure that you have some sort of pump to get the fluid into the transmission
before you get started because as I show in the video there is no dip stick
for this transmission that you can fill through. You also need to be sure
to use the proper fluid, I've got my fingers crossed that the MaxLife that
I used will hold up fine, so far it's been about 2 months since I shot this
video and it seems to be fine. In all it's not a bad job there are just
specific procedures that need to be followed to be successful with it.
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
2012- A YEAR OF EPIC CRASHES
Follow us on Facebook at https://www.facebook.com/MadRam11
MADRAM11 T-Shirts, Dvds, Hoodies, Koozies and more
I have had several people ask me to put together a crash compilation from
2012 so I finally got around to it. Hope you guys and girls enjoy. Be sure
and like and share the video.