02 Impala Front Hubs / Wheelbearings / Speed Sensors / ABS Traction Control Fault
Save One Thousand Dollars by making this repair yourself. Traction Control
Fault. ABS Warning Light. Front wheel bearings. Front wheel hubs. How to
DIY. Use plenty of anti-seize so its easier to take apart next time. These
hubs corrode and/or wear and the sensor can fail causing the traction
control fault on the dash along with disabling the antilock brake. Car
won't pass inspection with these faults. This is NOT a difficult repair and
can be completed in your driveway using simple hand tools. A shop may
charge you over one thousand dollars to do this job. Always use a jack
Original soundtrack by jcook007fix.
Chevy Impala 2008 won't crank and won't start, fix found!
Chevy Impala, 2008, does not crank or start. The battery and related
connections were thoroughly tested and determined to be OK, but when the
ignition key is turned to "Start" one click is heard coming from the front
(the engine area) and another click comes through the passenger side dash
but the starter does not crank the engine. The issue was previously
intermittent and the car would start after turning the key several times
for several minutes. The engine starts on first crank, if and when the
starter cranks but of late it has failed to crank at all. The security
light does not flash. Does anybody know what the fix is, it does not appear
to be an isolated issue.
Chevy Impala - engine noise
Engine noise from my 2001 Chevy Impala - Makes this noise when the belt is
off as well.
When driving the car & it does this it lacks power, not sure what it is...
any ideas are appreciated.
Clear check engine light for less than 5 dollars
More Tutorials on my CHANNEL: http://www.youtube.com/user/moccina
*This video is an EXPERIMENT I wanted to try on my car, and is for
INFORMATIONAL purposes ONLY. This fix is for off-road use. The content
shown in this video is not intended to encourage emissions test cheating.
I enjoy the process of testing theory because you always learn something
new, regardless of the outcome.
Using a spark plug defouler kit, I install a "buffer" in between the
downstream oxygen sensor and the catalytic converter. Quite often,
frustrated car owners get the P0420 code for reasons other than a bad cat.
I have heard of people getting the code just because they removed the
converter and reinstalled it. It can also happen if you run your vehicle
out of gas etc... etc...
It is also common for car owners to get the P0420 code, replace the
converter, and both o2 sensors-- only to have the code come back after 1000
miles or so. This can be a very frustrating, time consuming and of
course-- expensive venture. Here is one way to resolve the issue. Good
luck and have fun!
ABS Sensor Diagnostics, Troubleshooting and Repair
http://www.wellsve.com/ Anti-lock brake system diagnostics and repair. 2002
Honda Accord ABS code 15-1 and PCM code P0135. Step by Step wheel speed
sensor diagnostics and replacement.
"The information presented in this program is based on a specific
diagnostic case and might not directly apply to the vehicle you are
repairing. We do not represent or warrant that the information presented
is complete or error free. Please take all safety precautions. We
disclaim any and all liability for losses, injuries or damages in
connection with your repair."
How To Install Auto Carpet PART 1 Chevy Impala 2000-05 1AAuto.com
shows you how to install a carpet in your car or truck. Replacing your
carpet is one step in restoring an older vehicle or if you are looking for
a good way to clean up or get rid of a smell in the inside of your vehicle.
This is a little more challenging but can be done with common tools. This
video applies to the Chevrolet Impala, years 00, 01, 02, 03, 04, and 05.
How to Replace Your Fuel Filter ( Example 2004 Chevrolet Impala 3.8L)
A fuel filter is a highly over looked maintenance item. We recommend
changing it at least every 30,000 miles or according to manufacturers
specifications. Check your owners manual for location and service manual
for changing procedure. Always remember to relieve the fuel pressure before
braking the line open. Also don't forget the safety glasses. We change a
2004 Chevrolet Impala filter in the video so yours may be different in
appearance and location. Remember, changing the filter at proper intervals
will improve fuel mileage and prolong fuel pump life!
The automobile consist of:
• Fuel System: Purpose is to deliver fuel to the engine. It consists of
the fuel tank, pump, gauge/sensor, filter, pressure regulator and
• Air Intake System: Purpose is to clean and direct outside air into the
engine. It consist of air filter, ducts, air plenum and intake manifold.
• Exhaust System: Purpose is to
direct Exhaust gasses out of
combustion out of engine. It consists of the Exhaust manifold, converters, pipes and
• Cooling System: Purpose is to remove excess heat from the engine. It
consists of water pump, hoses, radiator, thermostat, cooling fan and
coolant recovery tank. Also the oil system serves as a cooling system as
well as a lubricating system. It consist of oil pump, pan, filter and
1. Clutch: Purpose is to connect the engine and transmission together. It
consists of clutch drive disc, driven disc, release bearing, clutch fork,
cable, slave cylinder, master cylinder. There are three types of clutch
systems: mechanical, cable and hydraulic.
2. Transmission: Purpose is to match engine speed to road speed. Two types
used are manual or automatic. These consist of gears, linkages, cables and
converters for automatics. A manual is connected to the clutch by a
flywheel and automatic by a flexplate.
3. Driveshaft: Purpose is to connect the transmission to the rear axle. It
consists of a slip yoke, shaft and universal joints.
4. Rear axle differential: Purpose is to change the angle of motion from
engine to the wheels. It also divides torque between the wheels. It
consists of a ring and pinion gear, carrier, bearings, crush sleeve and
5. Wheels/Tires: Purpose is to provide traction to the road as well as
carry the weight of the vehicle.
Vehicle Control Systems:
1. Brakes: Purpose is to slow and stop the vehicle. It consists of master
cylinder, brake Booster (vacuum or
hydraulic), calipers, drums, pads and rotors.
2. Steering: Purpose is to direct vehicle in the required direction.
Consists of steering gear (rack & pinion), steering wheel, column,
inner/outer tie rods, pump, reservoir, hoses and pipes.
3. Suspension: Purpose is to provide stability and handling while also
providing comfort to the ride. Consists of shocks, struts, sway bars, end
links, springs, trailing arms and bushings.
1: Heating Ventilation Air Conditioning (HVAC): Heats and cools interior
air to passenger comfort. Also circulates outside and inside air.
• Air Conditioning: Consist of condenser, compressor, accumulator
(receiver/dryer) orifice, expansion valve, hoses, evaporator, controls,
actuators and modules.
• Heating: Consists of heater core, valves, hoses and switches.
1. Power Generation: Creates electrical power to run all the electrical
systems. Consists of the alternator.
2. Power storage: Stores unused power to start the car and supply voltage
to the alternator to create more electricity.
• Both systems consist of wiring, harnesses, fuse, relays and modules
How To Install Replace Headlight and bulb Chevy Impala 00-05 1AAuto.com
1A Auto shows you how to repair, install, fix, change or replace the
broken, damaged, cracked, faded, cloudy, or chipped headlights. This video
is applicable to the 00, 01, 02, 03, 04, and 05 Chevrolet Impala models.
This process is easy and requires only a flat blade screwdriver.