Crown victoria magnaflow exhaust with cobra front bumper
this is my 2003 ford crown victoria P71, 3.73 gears, port and polished plenum, K&N FIPK intake system, custom tune by kurgan motor sports, gatorback belt, cat back custom made 2.5" Exhaust with magnaflow mufflers and an x-pipe with 3.5" tips, full audio system, custom dash with navigation, custom gauges, McCulloch HID conversion, clear corners, dynamated interior, custom made cobra bumper (i made it myself, no you cant buy it anywhere), niteshade rear lights treatment, 35/25 front/rear tints, FULL ALARM SYSTEM
2004 Crown Victoria 1/4 mile run
Here's my 2004 Ford Crown Victoria. Current mods include: aluminum driveshaft, 3.73 gears, full posi differential, Mercury Marauder airbox, 80mm MAF, '04 PI zip tube, ported and polished intake plenum and throttle body, 91 octane tune. This is my 4th best run so far after a 15.07, 15.09, 15.14.
Refurbish part 1.wmv - At Old Location in Fullerton, CA
Since Ford announced they will no longer be manufacturing the Ford Crown Victoria Police Interceptor, several law enforcement agencies that have come to rely on the CVPI for it's proven performance, safety, longevity and comfort are disappointed to see this car go so they sought out alternative options for keeping their existing fleet of CVPI's. That is where Wild Rose Motors Refurbishing division gave them the answer to the alternate option "Refurbish". LASD decided to do a test pilot black and white refurbishing and this 5 part video gives you a very clear picture just exactly what we can do to refurbish the CVPI back to better than new!
PART 1 of 5
2005 P71
91 octane Diablosport Predator tune tweaked by
Tuningsuperstore.com (email tune)
Disclaimer: I am NOT a LEO or a wannabe, just a private citizen that bought a retired Police car with NO emergency equipment and NONE will be installed.
2000 Ford Crown Victoria P71 Slicktop Unmarked Movie Prop Vehicle, LOT 251 CAR 5
2000 Ford Crown Victoria P71 Interceptor, Lot 251 Car 5
It's a movie prop car of mine for sale, company's liquidating*. 72,XXX miles. Brand new paint, cleanest they come. Black with blue interior. Currently installed police equipment:
*****SOLD****** Thanks everyone!
GoRhino Push Bar (Brand new, rare and discontinued for the -03 model years)
Blue Carpet, not the hard rubber floor
Jotto Desk Center Console
Clutter Catcher Center Console
Federal Signal Touchmaster Unitrol TM4
Speed Tech Lights 100W Speaker
TIR Overhead Slicktop Visor Lights
TIR Overhead California Steady Burn
STL LED Grill Lights
Code 3 Solid State Wigwag Controller
Federal Signal SMC5 331105 Signalmaster Controller
Federal Signal Signalmaster 8 LED Traffic Director
Kenwood TK790 Radio
Soundoff Halogen White/LED Red Dome Light
GPS/Cellular Combo Antenna for MDT
Wired for strobes in all 4 corners, all wires lead to trunk
Flowmaster 40's, stock Exhaust
Crown Vic on Hell's Revenge- Moab, Utah
Loran and I came across this guy while taking the Rhino out for a ride. Subscribe to my channel for more offroad videos of the Moab, Utah area!
The Aftermath of a Crown Victoria P71 Freeway Accident - Old Location in Fullerton, CA
A customer just recently purchased this Crown Victoria P71 from our dealership and was involved in a freeway accident.
It goes to show you just how safe these cars are, the other car which was a Toyota (you can see the word Toyota on the front bumper) was completely destroyed
My 2004 Crown Victoria Police Interceptor transformation into a Marauder clone.
My 2004 Crown Victoria Police Interceptor transformation into a Marauder clone. Bought from Texas Department of Public Safety in January 2008. The front clip was not changed out to the Marauder as these parts are very expensive. The header is about $250, front bumper is $400, headlights $100 and grille about $125. Then the rear bumper is $500 from the dealer to complete the whole look. Even junk yards wanted near retail for body parts. So I just added the Marauder corners and smoked headlights. Cheaper and still looks good and the average person has no clue the differences.
