More Videos...

Mazda rx-7, engine 13B, Rebuilding rotor engine, Final Stage

RX4 Coupe - Brapper

Rebuilding a Rotary Engine
A japanese guy rebuilding a rotary wankel engine

Wankel engine and Quasiturbine
motory s rotačními písty

WANKEL ENGINE
Motore Wankel in azione al motorshow di Bologna 2007

Mazda Rotary Dyno Massive 1664HP
http://www.braptv.com This engine has massive HP, WOW Awsome also on braptv.com Mazda Rotary Queen Street Racing 4rotor GT60 1664HP

Part 12: 13B Rotary Engine Rebuild - My 76 Mazda RX-5 Cosmo Restoration
Just as I promised last episode, it is finally time to build the engine! Part 12 of my RX-5 Cosmo restoration covers the entire process of building the 6 port 13B Mazda rotary engine. While this engine is a hybrid of GSL-SE RX-7 and Cosmo parts, the process is the same for any rotary from a 12A to a 13B NA, 13B turbo, 13B-REW or any other variant of the 13B. This video shows the whole process of the engine build, starting from measuring the rotors and covering everything else including clearancing the side seals, assembling the rotors, complete assembly the short block, setting the eccentric shaft end play and installing the front cover and everything underneath it. It's probably the most complete engine build video outside of what you can buy from the vendors, and as such, is an hour long. After this one, I'm going back to videos under 20 minutes. But for now, grab a beverage of your choice, sit back, and enjoy.

10a bridgeport ke30
bit of a video of my car. blame the women camerman for the closeups!

Mazda Rotary in Action
See a Mazda Rotary engine in action. A cutaway view of a model from the Detroit International Auto Show.

The Mazda Rotary Engine Part 1
Educational film by Toyo Kogyo about the Mazda Rotary Engine. Shows how the Rotary engine works with comparisons to the Piston Engine. Also shows the Mazda RX500 test vehicle on a banked circuit and the Mazda Cosmo Sport (or 110S). Originates from the late 60's.

Mazda RX3 Zoom Project Racer Full Throttle Friday & Bracket Meeting March 2009
Here is a compliation of a Full Throttle Friday and a Bracket Meeting at WSID of the Zoom magazine "Project Racer" build up car. This car runs a 13B turbo, Series 4/5 Mazda Transmission and a 9 inch Rear.

4-Rotor RX-7
SCOOT of Japan has built a 4-Rotor engine out of two 13B-REW's and dropped it into their demo RX-7.

Mazda RX3 12a bridgeport, first start.
My 12a injected bridgeport first start. Car was built in Sydney, Australia.

Mazda RX7 FD Twin Turbo 13B REW - Dyno
My 1992 Mazda RX7 FD Twin turbo on the Dyno. Producing 318.9 BHP reving to 8125 RPM @ 195 Mph in the rollers. Running an Apexi power FC and mapped by Carl Hayward of Hayward Rotary

Twin Turbo SBC 383 Mazda RX3 Bain Racing
Jake Bain Built and Tuned: Mazda RX3 Twin turbo & Tunnel Ram 383CID Small Block Chev Music is Metallica - Fuel