Delk performance cam kit consisting of the camshaft,valve sprigs,pushrods,and retainers,ported heads and intake, Dyno tuning and computer flash,bbk air intake ceramic shortie headers,high flow cats,H-pipe,40 series flowmasters and rolled tips out the back. 03 cobra front bumper,gt rear bumper, gt leather seats,shadow gray paint with ghost stripes 15 wide rear bullit chrome rims with 8.5s in the front, lowered on belltech sport springs and struts. hope you enjoy the vieo. Also have M112 Supercharger plans for this summer :)!!!!!!!!!
Cammed V6 Mustang w/Longtubes
I love the way it sounds now. MAC Longtubes, MAC o/r H-Pipe, Flow 40's.
Performance Mods were:
SUSPENSION & CHASSIS
-Eibach Pro Kit Springs
-Tokico Blue HP Series Front Struts and Rear Shocks
-Maximum Motorsports 4 Bolt C/C Plates
-BBK Rear Upper Control Arms w/UPR Spherical Bushings
-BBK Rear Lower Control Arms
-BBK Strut Tower Brace
-GT Rear Sway Bar
PERFORMANCE & DRIVETRAIN
-Custom X-Cal 3 93 Octane Tune (Courtesy of Fastlane Motorsports)
-Windstar Upper Intake Manifold Swap
-Ported & Polished Lower Intake
-EGR and Smog Pump Deleted
-180* Thermostat
-Comp Cams Custom Camshaft (218/226 - .50/.50 - 108*)
-MAC Long Tube Headers
-MAC Off Road H-Pipe w/MIL Elims.
-Custom Cat-Back w/Flowmaster 40's Mufflers, and 3.5" MBRP Tips
-ASP 25% U/D Pulley
-24# Injectors
-SSBC Front Drilled/Slotted Brake Rotors w/Hawk Pads
-Brembo Rear Rotors w/Hawk Pads
-8.8 Rear End w/T-Lok
-Motive Performance 3.90 Gears
-FRPP Aluminum Driveshaft
-STEEDA Tri-Ax Short Throw Shifter
-Stack Racing "Double Hook" Clutch Quadrant
-STEEDA Adjustable Clutch Cable
-Maximum Motorsports Clutch Pedal Adjuster
-UPR Single Lock Firewall Cable Adjuster
2006 Saleen cammed, slammed and blown
2006 Saleen...just half throttle through a few gears
Mods:
2006 Saleen
-Saleen Supercharger ported by Techco
-full Exhaust
-Comp SPR stage II cams
-Beehive Valve springs
-Steel Retainers
-Comp limiters
-Hurst STS
-3.6" pulley on Supercharger
-488rwhp @ 6.5psi
Turbo V6 Mustang
4.3 Stroker, turbo spec cam, 3 inch Exhaust, TMA turbo race kit. 675 rwhp an 549 ft-lbs torque at 17 PSI. I could pull on pretty much anything with 4 wheels....unless the tires started spinning.
supercharged/nitrous/v6/mustang
check out the full build at http://www.cardomain.com/ride/3119170. 15 psi, 38 wet shot Nitrous, and methanol injection. way to many mods to list....and yea it's a V6. 479hp and 530tq to to the rear wheels and over $17,000 in mods alone. not including the price of the car.
Ecotec 3.8L V6 Stage 3 Cam 2
Just another video of the cam sound but with a better camera. Still stock Exhaust tho. Getting a new one soonish. ;)
1995 Turbo V6 Mustang
I have not Dyno it yet so no official HP/TQ numbers.
turbo Kit built by Iron Horse Motorsports
Motor was also rebuilt by Iron Horse Motorsports along with Transmission/rearend installment. Big thanx to them
62mm precision/ T4
CxRacing 38mm Wastegate/ 9# spring
CxRacing BOV
Cxracing Boost Controller
3" Downpipe
Rebuilt 3.8 V6 with stock replacements (bored 0.030)
Stock Cam
Ported Heads
Rebuilt 1995 GT Transmission (Auto)
8.8 Rearend/3.73 gears
90mm MAF
42lb Injectors
BBK Adjustable Fuel Pressure Regulator
255lph fuel pump
BBK 56mm TB
Ford Racing Aluminum Driveshaft
VAP 1/2" Intake Manifold Spacer
SCT XCal 3 Tuner
BBK Underdrive Pulleys
Screamin Demon Ignition Coil
Supercharged V6 Mustang vs V8 Mustang
This a match up between a little brother V6 Mustang against a V8 SN 98 GT.
The V6 is stock with a bolt on Supercharger only pushing out 10lbs of Boost while the SN 98 is mostly stock. Both cars are automatics.
2002 3.8 V6 mustang exhaust no cats
2002 3.8 MustangExhaust
american muscle cold air intake
pypes x pipe no cats
magnaflow magnapack catback
i ended up putting the cats on a lil after this vid. CA has some mean emissions laws lol
Cammed Mustang GT
Another drive away video. This one is a little better.
Crower stage 2 blower cams
4:10 rear end gears
Flowmaster american thunder catback
O/R H-pipe
Steeda pulleys
C&L plenum
BBK 75mm throttle body
BBk cold air kit
Tuned by Performance Dyno
Tom Thompson AMP performance mustang fraud expert ripped me off
These are not nice guys don't be fooled!! No appreciation for customers..
Especially when you ask them why you are being lied to? And work takes longer or the parts don't appear to be what you paid for? or your parts go missing???
They will avoid taking responsibility for their own errors..
I caught them in a lie between another shop this is the owners reaction...Kicks me out...below are some other people who have had issues...Just do some homework before you get ripped off like i did..
http://www.stangnet.com/Mustang-forums/481096-dont-do-buisness-amp-az.html#post7992704
http://www.xomreviews.com/ampperformance.com
http://www.mightyMustangs.net/forums/index.php/topic/2434-amp-performance/page__p__31869
Supercharged V6 Mustang
Eaton M112 Blower/ 03-04 Cobra Supercharger On My 2000 V6 Mustang.
****All Stupid comments will be deleted.****
If you do not like it, do not post.