fast 3800 supercharger
2000 buick ultra. 3800 supercharged. thrasher pulleys. k&n cold air intake. hks Intercooler. gatorback belt. complete rebuild on engine and trans. 65mm throttle body. the quickest i have had it is 165. my gauge stops at 140 but i have the heads up display. as u can see in the video my gas gauge is broke
twin charged 350Z Built by Aaron Eddington turbo charged and supercharged 350z. I built it here in germany. Using Stillens stage 3 Supercharger kit and STS rear mount turbo kit with a GT35R Garrett upgrade on 1BAR stock internals. Tial 50mm BOV, tial wg, clutch masters fx4000 clutch w/fw, DPE st-10 Wheels. 19x10 front 19x11 rear. 245/35/R19 rear NiTTo NT555 225/25/R19 front. K sport suspension, Rose Diamond car Wrap. Carbon fiber hatch, stillen splitter.
1996 Monte Carlo - L67 Swap + Whipple
1996 Chevy Monte Carlo - L67 Swap (3800 Series II V6)
Major mods: 2.3L Whipple, DPP headers, ZZP S4 heads, IS3 blower cam, 1.7:1 aluminum roller rockers, 9.5:1 forged pistons, prep'd bottom end.
Mods coming soon: YT W/A Intercooler, new TB + adaptor, DP Nitrous
About the vid: this is a little older video we took just after we put the whipple on, and we had a couple issues that we were trying to fix, so this is a chopped down version of the original video that only shows the stuff worth watching. I have since fixed the issues, and found solutions to others (ie replacing the old lower adaptor with the YT IC).
I'll get another vid of it running once it warms up again, and I get the new mods done to it.
Twincharged 4A-GE roadtest
Testing the corolla in highway.
Top speed in this session... 255km/h
Engine:1600cc Toyota 4A-GZE with Rotrex Supercharger and Holset HX40 turbo.
Hestec fuel injection.
1/4mile E.T: 11.03sec/208.5km/h
Hoosier dot 225/50/16
twincharged ca18det twincharger ca18zt GT3076R Toyota Corona supercharged turbo engine rebuild.wmv
Series of pictures that shows the engine build process. The last motor was standard except for forged pistons. This motor was built by Mick at Micks Motorsport in Greenacre, NSW, Australia and has: Aries forged pistons, Spool forged H-beam rods, ACL race bearings, ARP head studs, O-ringed block, copper head gasket, Tomei Procam 270IN/EX Duration 8.8mm Lift cams, Tomei valve springs, Supertech titanium valve spring retainers, adjustable cam gears, Gates performance timing belt, new Nissan oil pump. From this point, i bolted on all my old gear: Standard inlet manifold, 770cc injectors, custom steam-pipe Exhaust manifold, Garrett GT3076R with 0.63 ex housing, Tial 44mm external wastegate with 2" pipe, Volvo fire-engine? 250hp Supercharger, 'The Blower Shop' Gilmer style pulleys, 3" Exhaust system with Boost actuated 2 1/2" Exhaust by-pass, standard S13 5-speed with Extreme 5-puck brass button drag clutch. I also re-did the intercooling piping and blower by-pass valve, removed about 1 metre of pipe, fitted a new PWR Intercooler (1), and an ebay Intercooler (2), plumbed back the blow-off valve into the turbo inlet, fitted a box over the pod filter, and Matt black painted everything. The air path and plumbing path is the same as the 'Lancia Delta S4', so if you Google image that, you will know my system.
We left the run-in tune at 280hp @ wheels, with the blower set at around 12psi (it can go to 20psi, adjustable via a turbo-smart bleed valve on the blower by-pass valve actuator line picking up pressure on the blower outlet pipe), and set the turbo at 19 psi via Haltech Boost control on Tial wastegate (it will be set at 28psi when i go to E85 and I.D 2000 injectors, plus we will dial in the cams).
Its easy and fun to drive as no lag, and has a very linear torque curve from around 2500rpm up to 8000rpm. It sounds unique as combination of blow-off valve sound, waste-gate chatter, turbo whistle, screamer pipe, blower whine, and Exhaust by-pass noise ...
3800 Series 2 Modding Basics
Mods and Vendors list
Short Stack Intercooler
UD Water Pump Pulley
UD Alternator Pulley
Solid Motor Mounts
3 Inch Downpipe
Intercooler Pump Harness/Relay
Shortened Dog Bones
Rear Strut Tower Brace
Aeroforce Scan Gauge
3 gauge Pod
Throttle Body Heat Shield
Throttle Body Spacers
Ebay user "American Superchargers"
Modular Pulley System
All other parts not listed were purchased at various auto parts stores,Ebay users I dont remember and Walmart.
Twincharged Cobalt SS 412whp ZZP Tuned MYBADSS
Here is my Supercharged and turbocharged aka (Twincharged) 2007 Cobalt SS. The install was done at ZZP and it is there custom Twincharged Kit.. I asked for 400whp and they gave me 412whp.. This is just the beginning and will be updating with more mods and results.