A little video about my 2005 Mazda RX8 in Germany near Stuttgart ;) Visit www.MyRx8.de for more informations.
Please remember: This is no professional Video. It should be only a fan video, just 4 fun. ;)
OUTSIDERS JAPAN MOVIE BY DRIFTWORKS. HD Drifting Documentary DVD
After 10 years of being a part of the drift scene, Phil Morrison and James
Robinson from Driftworks finally took a tour of Japan, accompanied by film
maker Al Clark, and guided by Mitto Steele.
The goal was to see where drifting originated. To find out why it has
advanced so much, and why the drivers will often risk everything to do it.
Full Boxset available from www.driftworks.com
Like Outsiders FB Page: www.facebook.com/OutsidersMovie
Like Driftworks FB Page: www.facebook.com/driftworks
I had a problem with my rx8, it was flooded, it flooded cause i moved it to
my garage and turn it off without warming it up, after that didnt wanted to
My uncle fixed it, he took the fuel fuse out, then he tried to start
it for 8 sec. then waited 5 sec. then tried to start it again for another
8 sec. He tried the same for like 4 times, then he put the fuse back on.
Then he tried to start it but it started then flooded again. then he
took the fuse out again and tried to start it one more time it started for
a little bit like 2 sec. then he put the fuse back on and bammm it
1650 HP RX7, "The Sleeper Part 2", Scary and Funny, from NRE.
Nelson Racing Engines 1650 HP RX7 road video of this crazy sleeper.
Awesome power in this tiny car. This car is really scarry and very fast.
Some very funny video. I laughed a lot. More information and downloadable
videos for your IPOD and PS3 can be found at at
http://nelsonracingengines.com. and http://nelsonsupercars.com.
Extreme cold start -33C (-27,4F), no pre-heat, Mazdaspeed 6 turbo
Please, read description below! It will most likely answer your question.
We were on a ski trip in northern Finland. The whole week was freezing,
-25C to -35C all the time. Obviously, it was too cold to ski. The car layed
completely unused on a parking lot for five days. When leaving, I had to do
this cold start, and thought it would be worth filming. Battery was
original, about five years old, and it survived really well. No Engine
heater, battery heater/charger or any other device was used. Pure cold
Idle revs are higher at low temperatures, thanks to automatic choke. Nobody
touches the accelerator at any time. I'm actually releasing the clutch @
0:43 to keep revs low, I thought cold and thick transmission oil would
cause some troubles to engine and lower the revs. If I remember correctly,
idle revs were somewhere around 2500 - 3000 rpm during the start.
The coldest start before this was -22C. It's much more gentle for the
engine than this. However, after this I got new battery and a block heater,
just in case. I know continuous starts like this will kill the engine very
quick, but doing it once hardly did any damage. Car had 150 000km (almost
100 000 miles) on it when I sold it, and it still worked fine.
Montaje del Motor Renesis - Mazda RX-8 - NO REBUILD
Proceso de remontaje del motor Renesis de un Mazda RX-8. NO ES UN REBUILD
de Motor puesto que no se han cambiado ninguna junta de estanqueidad,
sellos de aceite o sellos de motor. Se ha limpiado todas las piezas y se
han reutilizado, con el propósito de practicar el montaje del motor y
almacenarlo de una manera mas compacta para en un futuro rehacerlo con
piezas destinadas a su uso en competición.
Manual de Taller:
Part 12: 13B Rotary Engine Rebuild - My 76 Mazda RX-5 Cosmo Restoration
Just as I promised last episode, it is finally time to build the engine!
Part 12 of my RX-5 Cosmo restoration covers the entire process of building
the 6 port 13B Mazda rotary engine. While this engine is a hybrid of GSL-SE
RX-7 and Cosmo parts, the process is the same for any rotary from a 12A to
a 13B NA, 13B turbo, 13B-REW or any
other variant of the 13B. This video shows the whole process of the engine
build, starting from measuring the rotors and covering everything else
including clearancing the side seals, assembling the rotors, complete
assembly the short block, setting the eccentric shaft end play and
installing the front cover and everything underneath it. It's probably the
most complete engine build video outside of what you can buy from the
vendors, and as such, is an hour long. After this one, I'm going back to
videos under 20 minutes. But for now, grab a beverage of your choice, sit
back, and enjoy.
Best Of Rotary Sounds
Please Check Out My Facebook Pages
"Terminator" Vs Range Rover - TerraMax - Top Gear - Series 19 - BBC
James May assesses the new Range Rover at Nevada's Automotive Test Center
for the ultimate challenge against an autonomous military machine - the
Terminator of all terrain vehicles; The TerraMax.
Subscribe for more awesome Top Gear videos:
Top Gear YouTube channel: http://www.youtube.com/topgear
TopGear.com website: http://www.topgear.com
Top Gear Facebook: http://www.facebook.com/topgear
Top Gear Twitter: http://twitter.com/BBC_topgear
This is a channel from BBC Worldwide who help fund new BBC programmes.