Ford Ranger Needs Help
UPDATE: The Ranger is fixed. Apparently the mechanic who installed the timing belt did not correctly adjust the crank shaft position sensor. It's all fixed now and runs like a champ. Thanks all for your ideas.
1992 Ford Ranger 2.3L 4 cylinder, manual. It threw the timing belt. Replaced it and the crank shaft censor but the thing stalls out and dies. It will start right back up and idle like a champ. I replaced the ICM, Relays, Coil packs, and it still dies. The fuel pump is good with good fuel pressure. The mechanic told me it wasn't a timing issue because there is no distributor to set the timing.
Any answers or tricks or pointers would be great.
Outer Weatherstrip Replacement
How to replace the outer weatherstrip on the door of my 1996 BMW 318ti.
1. the new strip
2. plastic body putty spatula
3. rubber mallet
4. about 2 minutes of time
My 318ti uses part number 51218198053 (left door) and 51218198054 (right door). Check at realoem.com to verify yours uses the same part. My purchased mine at GetBMWparts.com for $27.42 each plus shipping.
My Classic Car - Replacement Weatherstripping
http://www.classicindustries.com Sean Hughes from Classic Industries returns with an assortment of OER quality parts for replacing old and damaged weatherstripping to add the finishing touches to your classic restoration.
1964-72 Chevelle Trunk Weatherstripping Tips
We see a lot of cars at car shows with their 1964-72 Chevelle Trunk Weatherstripping installed incorrectly. Here we will demonstrate the correct orientation of the weatherstripping in the trunk channel.
1983 ford ranger
My 1983 Ford Ranger a lot of surface rust but that's about it. Needs a lot of work and TLC and a few parts but i like it. Some people can relate to it. Like, Rate, and Comment ideas for the truck besides junk it! More videos of my progress soon!!
351c ranger on ramp take off 003
Bigger tires (275ZR40-17) still leave something to be desired when gouging on it from a freeway on-ramp, even with a power-sucking C6 tranny. Time to go with some 315 or 335 series drag tires before swapping in the 4.10 rear.
Ford Starter Solenoid Troubleshooting, Replacement and Function
http://www.wellsve.com/ This video demonstrates a Ford fender mounted solenoid function, testing and replacement.
The information presented in this program is based on a specific diagnostic case and might not directly apply to the vehicle you are repairing. We do not represent or warrant that the information presented is complete or error free. Please take all safety precautions. We disclaim any and all liability for losses, injuries or damages in connection with your repair.