Thrush Welded muffler SPL test With Pontiac 406
1967 Pontiac Tempest with thrush welded mufflers. his test was to see what kind of spl we could get out of the car at various areas around the car. This has Hedman headers with 6 ft of straight 2.5" SS pipe to the Thrush mufflers. Then it exits via mandrel bent Flowmaster 2.5" tailpipes.
Audio is a little crappy. I apologize, the camera isn't designed for great audio. But they sound mean!!!
Thrush Welded 87 350
My 1969 GMC c10 SWB, finished putting an 87 tbi 350 after converting it to carb. Sorry for the shitty sound. Hope to have some burnout videos soon
96 Crown Victoria P71 H pipe with Thrush Welded mufflers
After running side pipes with no mufflers or H pipe for a couple years, I finally got pulled over for it. I decided it was time to put mufflers back on, so i put the original H pipe back on with a pair of Thrush Welded mufflers and some turndowns. Too quiet for me, but it still has a decent sound.
74 Chevy Nova
My 74 Nova with 357 small block. Full length Summit 3 inch Exhaust with Thrush Welded 2 chamber mufflers. Comp HR276 roller cam, 9.5:1 compression, Trick-Flow heads, etc... Has run 8.13 in the 1/8th mile with 1.75 60ft time.
thrush welded muffler
cheap Exhaust job i did on my '93 gmc sierra 4.3L. Parts used: a thrush welded muffler 2.25" center inlet/dual outlet($32 from Summit), 10' of 2.25" aluminized Exhaust pipe(about $17), one Exhaust clamp(about $3), one universal hanger ($5), 2' of 3.00" pipe used for tips($4). $61 total. the welder and Exhaust bending machine sure come in handy.
1967 Tempest new camshaft Ultra Dyne 220/226 @ .050 in Pontiac 400
Traded my friend Robert for this camshaft. Came already broken in with a matched set of lifters. I swapped it out over the last month or so. I still have to install the temp gauge in the car, so I am not running it that long yet. Put around 2 miles on it. PULLS!!!! Hard!!! I have to find the coil bind on the springs. might have just increased redline!!!
1957 Chevy dual exhaust
57 chevy with a 350 crate drunning 300hp. Long tube headers into dual 2 chamber thrush welded mufflers
1995 2.3L Ford Ranger w/Thrush Welded Muffler
This is my '95 Ranger I uploaded for those guys curious about how a chambered muffler would sound on a 2.3. I am running the stock cat, resonator delete, and have added this muffler. It's 2 1/4" piping from the header to the muffler and goes into a 2" single Exhaust pipe. Muffler cost me about 37 bucks at Advance Auto Parts. Well worth the money and sounds great. Almost no interior drone as well.