More Videos...

FAKE CAMS! 4.6L Ford Engine
This is a little trick to show your friends, if you have a 4.6L Ford engine. Makes it sound like your engine has cams. I'm pretty sure this trick will work on other vehicles as well, you just gotta find the right vacuum tubes to unhook. DO NOT drive your car like this.

2004 Crown Victoria 1/4 mile run
Here's my 2004 Ford Crown Victoria. Current mods include: aluminum driveshaft, 3.73 gears, full posi differential, Mercury Marauder airbox, 80mm MAF, '04 PI zip tube, ported and polished intake plenum and throttle body, 91 octane tune. This is my 4th best run so far after a 15.07, 15.09, 15.14.

22-60 pull
ford 5.4 swapped crown victoria 22-60mph pull

crown vic with heads and cams
new ported heads and cams

Crown Vic Cammed
My 99 Ford Crown Victoria P71 Cammed, Exhuast video

Cammed Crown Vic Cold Start
Hitech stage 2 cams, and a lot of other stuff.

2001 Ford Crown Victoria P71 Police Interceptor Supervisor Unit
50k miles SOLD FOR $6995 WWW.CMAUTOWERKZ.COM

New engine Installed
2006 CVPI engine installed, Hitech stage 2 cams, marauder MAF, 24lb injectors, underdrive pulleys, 3200 stall converter, shift kit, 3.55 gears

97 Marquis with lopey comp268H cams
4.6L SOHC motor with Comp Cams Extreme Energy XE268H Cams installed and degreed. enjoy.

MARAUDER DONUTS, BURNOUTS, $TUNT MAN CHRI$
MY STOCK O3 MARAUDER BOUT TO PUT SUM NEW TIRES ON HER!

Comp Cam XE270 AH in Windsor heads on a 2001 Mustang GT
Comp Cam XE270 AH, BBK Shorties, BBK X Pipe, Flowmaster single chamber. Came out with 278RWHP 305RWTQ on the stock bottom end with 125k miles all bolt ons, and a tune. I was thinking I would break the 300RWHP mark and probably would have if it was a fresh motor. The heads are off a 5.4 Super Duty, for the most part they are the same as the Romeo heads and bolt right in, just the valve covers are the main difference, also the Windsor heads have PI cast all over them and the Romeo heads fail to have it anywhere.

Lightning Swapped Crownvic
QuickCrownVic's Lightning Swapped Crown Vic

97 Mustang GT w/00 Motor & Comp Cams
263 rwhp / 277 rwtq Mod list: 00 PI Motor, K&N FIPK CAI, C&L Plenum, BBK 75mm TB, Comp XE262AH Cams, BBK O/R X-Pipe, Steeda UDP's, Motive 390's, MGW Short Throw, 17x9/10.5 Cobra R's, NT555R Extreme DR's, Eibach Pro Kit Springs, Tokico HP Blues, UPR/Shark CC Plates, MM FLSFC's, TrickFlow Rear End Girdle and a Freshened Up T-45 5spd w/11" Cobra Flywheel and Clutch Assembly, Custom Tuned at www.SWTuning.com

FORD 5.4 with cam phaser issue
5.4 warmed up and at idle, 1200rpm, 2500rpm, 1500rpm and back to idle.

Mustang w/ XE262AH cams
My horse with P.I. heads , imtake, 3000 stall, 3.55 gears, MAC 80mm Mass Air, Msd Ignition Coils and Comp Cams XE262AH cams with SCT Flash tune by 5 Star Tuning of Florence,SC