WELL I FINALLY GOT AROUND TO DEADNING THE TRUNK LID OF MY CAR ONE ROLL ON PROBALLY 2 MORE TO GO SHOUT OUT TO EXO THE PEEL AND SEAL IS GREAT HUGE SAVINGS ON BUYING IT COMPARED TO OTHERS SUB COMMENT N RATE THANX
Sound Deadener Heat Test Comparison
Sound Deadener Heat Test Comparison
In this video you will see a heat test comparison between the following deadeners:
Peel & Seal, eDead 45, eDead 80, FatMat 50 mil, Dynamat Extreme, Second Skin Damp, Second Skin Damp Pro, Audio Technix 60, Audio Technix 80, and RAAMmat BXT II
Peel & Seal slid a little more than 1/2", FatMat slid 1/4", the "aluminum" layer on eDead wrinkled up, all the other samples look great. I got a huge headache from the Peel & Seal and FatMat. Both smelled absolutely horrible. I do believe that the "aluminum" layer on eDead is actually plastic.
Peel and Seal
well i wanted to try it so i did, and just the little bit i put on there did make a difference, and i like it, im soon going to do my roof next
Audio Technix Sound Deadener Before and After Install Video
A before and after test of Audio Technix Sound Deadener. It also shows how to stop trunk rattle using Audio Technix Deadener. Audio Technix is better than Dynamat and is only a fourth of the price!
For information on how to order go or get in contact with Audio Technix go to:
For other questions about the deadener go to:
or email us at Coleman@AudioTechnix.Com
sealed my trunk 02 mustang dual 15" BTLs
I decided to seal off my trunk from the passenger compartment to gain a lil spl. it seems like now its louder with the windows up, before it sounded louder with the windows down. also u feel the lows a lot more now. my system- (2) 15" Fi BTL's, (2) Rockford Fosgate t20001bd's, (4) alpine type s 6.5s, (1) alpine mrp-f300, (1) optima yellow top, (1) kinetik hc2000, (1) kinetik hc 600, (1) Iraggi 200amp alternator, Big 3 in 1/0 gauge, (2) positive runs of Kicker 1/0 gauge. (1) negative run of 1/0 gauge, Kicker 8 gauge for speaker wire (BTL's), Jensen p.o.s 7" flip out touch screen head unit.................................... .................... ........................................ .................... ........................................ .................... ........................................ .................... ........................................ ..............Copyright Disclaimer Under Section 107 of the Copyright Act 1976, allowance is made for "fair use" for purposes such as criticism, comment, news reporting, teaching, scholarship, and research. Fair use is a use permitted by copyright statute that might otherwise be infringing. Non-profit, educational or personal use tips the balance in favor of fair use.
Dynamat 2007 Lexus ES350 In Depth Before and After Review
I bought a bulk pack of Dynamat (36 sq ft) for my 2007 Lexus ES350 to use in the trunk and the rear deck. This video goes through several songs before and after dynamat as well as the tapping demonstration where I knock on the trunk before and after. NOTE: Dynamat will NOT take all your rattles away as you can see, what it will do is reduce them greatly and increase the sound from your bass instead of it being lost through the trunk and rattling. I highly recommend it for anyone with a subwoofer, my car rattles much less than it used to, especially in the interior, my side view mirrors even shake less just by what I did in the trunk. Also, 36sq ft of dynamat was not enough for the WHOLE trunk but a good part of it, and it is true that if you double or triple layer it it will perform much better than a single layer. I will be uploading an installation video sometime soon so be on the lookout for it. I hope this video helps, I wanted to try and make the best dynamat video of before and after that I can, so ratings and comments are always appreciated! Thanks everyone!
Peel N Seal (sound deadened my trunk)
I am a huge fan of Dynamat but I was looking for a more cost effective solution to sound deaden my trunk. I bought a 8" x 33 ft roll of Peel N Seal ($30) from Rona but I am sure you can find this stuff at any home hardware stores. The results are impressive and I am very pleased with my install. The car is a 2010 Toyota Corolla.
1994 Nissan Sentra - Sound Deadening
In this video, I went through the process with help of my best friend, to install sound deadener in the rear my car. Peel & Seal is meant for roofing and gutters, but this is a cheap alternative to stuff like PHATMAT, SecondSkin, DYNAMAT and others.
In my experience, it has helped reduce the majority of the rattle and flexing from my subs.
I also want to note to those that say it smells...it doesn't smell at all. In Oregon, it can get cold and then hot at random times and it has still stayed in place and without an odor.
I had to use three rolls to just do the back. I will make another video of doing the ceiling. I still get some roof flex and annoying rattle from it :(
I wanna give shoutouts to my best friend Austin for helping out and EXO for the tip for this.
Roll Yo Bones - Mad Mike & Bass Mekanik
You'll Be Under My Wheels - The Prodigy
Forever (feat. Kanye West, Lil Wayne & Eminem) - Drake
Make A Movie (feat. Chris Brown) - Twista
Type R Door Sound Proofing
Civic Type R (ep3) Door sound proofing demonstration for the civictype-r.co.uk owners club.
It shows the basics of how to apply 6 sheets per door of sound deadening material
Dynamat: Before and After
I Dynamatted my trunk and doors, and what an improvement. Thanks for watching. BTW-I chose this song because it was one of my favorite songs at the time. If you don't like it, too bad. Go make your own video. (and the cheapest place I've found so far is amazon just in case you're wondering ;)
I disabled comments because too many losers without a life kept leaving stupid comments. GTH. :p
Sound deadener - Before and After
Added some Second Skin Damplifier to my roof. HUGE difference even with just one layer. I highly recommend this stuff, it complelety fixed my noise problem.
My bass sounds sooo much cleaner it's like a different system.
Thermo-Coustic Sound Deadener from Eastwood
BUY It Here: http://www.eastwood.com/eastwood-thermocoustic-material.html
Thermo-Cousitic sound deadening material is designed with Butyl Rubber material 0.60" thick and bonded to a high performance aluminum facing for an overall thickness of 0.070" thick. We then apply our "hi-tack" adhesive that allows you to stick this material in any application or orientation. The material has been tested equivalent to other brands costing much more. Thermal reductions will be greatly noticed in the interior along with reduced road noise and driveline vibrations.Our material will conform to any interior, door panel or trunk area & will reduce interior noise/temperature in your ride.
Check out the video.