Destroying an Engine in 30 Seconds :(
Questionable Cash for Clunkers program means all trade ins get a toxic dose of chemicals which destroy the engine in seconds. Check it out...
No Crank, No Start Diagnosis - EricTheCarGuy
Visit me at
http://www.ericthecarguy.com/
Whenever you have a no start condition when attempting to start your vehicle it's important to make the distinction between "no crank, no start" and "crank, no start" situations as they are treated differently. This video covers what I do when confronted with a 'no crank, no start' situation and in this case it's a worst case scenario so be sure to watch till the end.
Starter diagnosis video
http://www.youtube.com/watch?v=RKjdnQ0sHQc
No start basics video
http://www.youtube.com/watch?v=FBUYs539cy4
Parasitic draw video
http://www.youtube.com/watch?v=KF1gijj03_0
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Stay dirty
ETCG
Compression Testing and What You Can Learn From It - EricTheCarGuy
Compression Testing and What You Can Learn From It - EricTheCarGuy
Here is a video on performing a compression test on an engine to assess it's mechanical condition. An engines ability to compress air and fuel is directly proportional to it's performance since an engine is nothing more than an air compressor once you take away all the controls. A compression test is a good general test that will give you an idea of the engine's overall health but it does not give specific information on what the problem is should there be one, for that a "leak down test" would be required, here is a link to that video.
http://www.youtube.com/watch?v=WgrfT0LFMhc
However if you find yourself looking for the source of a performance problem with an engine, this is a great place to start. This test is often overlooked in favor of looking at the fuel or ignition system, I think that's a mistake, if an engine can't perform mechanically no amount of electronics will make that better.
Recently, I hit the 500 subscriber mark and I'd like to thank all of my subscribers past, present, and hopefully in the future for that. I enjoy making these videos and the fact that you seem to like watching them means a lot to me. So, thanks for subscribing, rating, and commenting, those little contributions make it all worth while.
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Also see the video I did, "Octane Ratings and the 4 Stroke Engine Cycle" for more information on how compression works and why it is important.
http://www.youtube.com/watch?v=8VWEwEveGTQ
Thanks for watching and stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
How an engine works - comprehensive tutorial animation featuring Toyota engine technologies
Animation I created for Toyota that gives an overview of the components of an engine, how an engine works and some of Toyota's valve, intake and Exhaust technologies. I wrote, directed and storyboarded the video. It was for training purposes only.
www.curvedspacecreative.com
See other videos at:
http://www.youtube.com/watch?v=zA_19bHxEYg
http://www.youtube.com/watch?v=UpP6WYKrtS4
http://www.youtube.com/watch?v=MMrBDdLGB20
http://www.youtube.com/watch?v=hwwXukJaTlM
How to Diagnose A Bad Clutch - EricTheCarGuy
Link to clutch replacement video for this car. http://www.ericthecarguy.com/vmanuals/vm/2002-ford-focus-clutch-replacement-vmanual
Visit me at: http://www.ericthecarguy.com
This one will end up being part of a larger series of videos about clutches and their diagnosis and replacement, I'm even going to post a video on 'How To Drive A Stick Shift' as part of this series. So in this installment I cover the basic steps in determining if you NEED a clutch or not.
---
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
http://ericthecarguy.com/
Visit EricTheCarGuy Forum
http://www.ericthecarguy.com/forum/default.aspx
Visit my Facebook Page:
http://www.facebook.com/EricTheCarGuy
---
Stay dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
cylinder leak test how to check for bent valves
i did this video to help some of you not get ripped off when buying a motor.
i will be doing many videos of how to test parts and what to look for. please email me if you have question or what to learn how to test something else pls52202@yahoo.com or thinkperformancemotorsports@gmail.com
relación de compresion motor , compression ratio engine.wmv
how to calculate an engine´s compresion ratio. / como calcular la relación de compresión de un motor.
spreadsheet / hoja excel abailable at this link: www.sportmini.es
http://www.sportmini.es/calculos/parametros%20de%20compresion%20para%20mi%20pagina%20web.htm
