2002-2008 Ford Explorer Thermostat Housing Coolant Leak Repair Part 2
Purchase the complete kit from this video here: http://www.apdty.com/Ford_Thermostat_Explorer.wws
Learn to diagnose and repair a 2002 Ford Explorer coolant leak. In this video we are replacing the thermostat housing where the coolant was leaking.
Part 1: http://www.youtube.com/watch?v=2pRSUySTuEI
2002 Ford Explorer Thermostat Housing Coolant Leak Repair Part 1
Purchase the complete kit for this repair here:
Learn to diagnose and repair a 2002 Ford Explorer coolant leak. In this
video we are replacing the thermostat housing where the coolant was
Part 2: http://www.youtube.com/watch?v=As7xUNY0S_I
1995 Ford Explorer Radiator Repair
Purchase this radiator here:
Click the above link to find the radiator for your vehicle. In this video
we'll show you how to replace the old radiator on this 1995 Ford Explorer.
Radiator coolant and transmission fluid have been leaking into the radiator
and mixing. This will cause a large mess and must ben repaired and flushed.
1995 Ford Explorer Waterpump Repair
Find the water pump and other cooling parts for your vehicle at:
Click the above link to find the water pump that fits your vehicle. In this
video we'll show you how the replace the water pump in a 1995 Ford
Ball Joint Replacement -Ford Escape
Ball Joint Replacement -Ford Escape. Here is a 2002 Ford Escape in need of
a ball joint replacement. Here we go through the steps it takes to replace
a ball joint in this Ford Escape.After jacking the Escape up and taking off
the tire, we proceed in taking off the brake caliper.After that it is one
pinch bolt,then press out the old ball joint and in with the new ball
joint. Be careful when working on any vehicle when it is jacked up. Be
safe and take all safety precautions.
Replacing your Water Pump
Anthony @ DIYautotech taking you through the steps on how to:
1. Notice a problem, narrow down to a component, test component, replace.
2. Replace your water pump
3. Replace your serpentine belt
4. Flush & Fill your coolant reservoir.
If you have any questions always feeel free to ask via comments.
Don't forget to SUBSCRIBE!!!!!
GATES: Cooling System Flush: Cleaning Neglected Vehicles FULL Version
The engine cooling system is one of the most critical elements of engine
performance and reliability but is often the most neglected maintenance
item for all vehicles on the road today. Common flush procedures are not
enough to remove the amount of contaminants present in neglected vehicles.
With the Gates PowerClean tool, technicians can now recommend a more
thorough flush procedure to consumers. Doing so will increase engine
cooling efficiency, protect the life of the water pump and eliminate
unnecessary customer comebacks.
Fuel Filter Replacement 2006 Explorer
This is a video showing how to replace the fuel filter on a 2006 Ford
Explorer. Other years, makes, models may or may not be similar. Thanks
for watching! Check out www.youtube.com/roadragecustoms for more DIY
automotive repair videos.
02 Ford Explorer Heat Blend Door Actuator Simple Fix - No Tools Needed
This is a 02 Ford Explorer that has a broken and worn heat blend door
actuator. The labor at a dealership with parts is approx $700-800 if you
take it to the pros, The cost of the part is approx $65.00 if you want to
do it yourself, or you can give this a try and save even more.
The part I will be referring to later in the video is a plastic flap, which
is approximately 3" long and is located almost directly behind the wires
you see in the video along the edge of the wall compartment. It needs to
be pushed down, and you will hear it as it reaches the correct position.
Once you locate this, it will only take a few seconds to change in the
The blend door will easily work with the air condition control knobs, but
once you switch it to cold air, you will need to switch this back manually
as in the video.
Hope this tip helps.