Grand Prix GXP Flowmaster Cold Start
2006 Pontiac Grand Prix GXP Cold Start. Listen to her burble at idol!
Ill post a better video later.... for now this will do.
Mods:
Custom 2.75" Flowmaster 40 Series Dual Chamber Mufllers
Custom High Flow Downpipe
RES Delete (if you couldn't tell)
K&N Air Intake
LED Tail lights
5% Tint
2008 Pontiac Grand Prix GXP V8 Start Up, Exhaust, and In Depth Tour
In this video I give a full in depth tour of the 2008 Pontiac Grand Prix GXP V8. I take viewers on a close look through the interior and exterior of this car while showing details, over viewing of features, and noting unique styling cues to the vehicle itself. I also show the engine and the details of it, start it up and see how it sounds under acceleration. A thorough tour/review of this car designed to give others a greater overall appreciation of the vehicle.
2006 Grand Prix GXP Magnaflow Cat-back.
2006 Grand Prix GXP Currently the mods I have done are: 160 T-stat, Cold Air Inductions Intake, Magnaflow Cat-back. This is a really fun car to drive, just love it!!
Modded Grand Prix GXP 5.3L LS4
Did a pass around 50ish to hear the Magnaflow Cat-back Exhaust. Then did a 0-120ish. Started out half throttle and slowly worked it to about 3/4. Had to slow down because of a sharp turn. Thanks for watching.
How to Change a Wheel Bearing (short and fast version)
This video shows how to change a pressed bearing in a Ford, specifically a 95 Ford Windstar, but this method will be similar for all pressed bearing vehicles. The main steps are to take off the spindle nut, tire, brake caliper, and rotor. Then remove the bolts from the lower control arm ball joint, tie rod, and strut. Remove the steering knuckle, then press out the bearing and hub/spindle. Then press in your new bearing and hub/spindle. This job is a little more complex but can still be easily done by any amateur mechanic. You will save $400-800 depending on your vehicle. Pleas comment, like and subscribe if you liked this video!
Tags:
how to remove a pressed front bearing, how to remove a front bearing, 2003 Mazda Front Wheel Bearing Replacement (Press In Type Bearing), How To Remove Pressed-on Bearings - EricTheCarGuy, Wheel Bearing Removal with Harbor Freight Universal Tool BMW 325i Rear Front, bearing, press, pressed, pressed bearing, front bearing, front wheel bearing, diagnose, how to, diy, ford, windstar, ford windstar, Pressing out a front wheel bearing, harbor freight, bearing kit, How to: Remove & Install A Truck Hub Bearing Assembly with Timken, How to remove a rusted wheel hub bearing assembly the easy way, trick, mazda, ford, lincoln, gm, truck, van, car
Disclaimer: this video is for educational purposes only. Fix your car or truck at your own risk. I take no responsibility to what you do to your vehicle. This is how I fix my car and it works for me.
