Setting the engine up and breaking it in.Remember this engine is just being started after a rebuild so that's why it's smoking from the assembly lube and the rack will be set-up to stop the hunting etc etc. Then the oil is changed and the engine painted. These engine's go into Euclid mining rock trucks,and they were in many other equipment/vehicles.The engine has rebuild heads,turbo's, blower, water pump,all internal parts and the air compressor All done in the great north of Canada
This is our 24 cylinder Detroit that we are putting in a custom 359
Peterbilt. It will use an Allison Transmission, and the engine will be in
the front of the truck. We are starting off with 40 foot 4" X 14" rectangle
rails, not sure how long it will end up being.
Twin Turbo Ferrari Testarossa on Engine Dyno
Twin turbo Ferrari Testarossa on Engine
Dyno. The motor is a
4.9L flat 12 which has been upgraded with EFI via a Bigstuff3 PRO SEFI ECM
and twin Precision turboturbochargers. At this stage the motor is running
6psi Boost and has no internal
modifications. We ran it from 3500rpm to 7500rpm and it produced 650hp and
600lbs*ft of torque. Enjoy!
Also I just posted a new video on my channel showing a walk around of the
car with some of the new wheels and brakes mocked up on it. If you guys are
interested check it out there.
Supercharged home made Straight Eight by Desperate Dan Vid 2
Built in a shed, it fired up first go. I was hoping it would sound real
lumpy like a drag engine, but it runs too smooth, and it's too quiet even
with unsilenced 9" pipes! The timing was a pain to sort out the Rover
distributor runs backwards, I had to take the heads off to work out the
firing order!!! See the shed it was built in on Vid 1.
Added May 2012: OK, my nails are dirty, maybe because I'm an engineer &
build stuff? Maybe your nails are clean because you can't build eff-all &
just sit behind your computer? C'mon folk, get a life.
v-12 gas 3,200 cubic inch engine
a climax v-12 with a 7 inch bore and stroke 270 cubes per cylinder was used
for pumping water in michigan in saginaw there was six and this is number 6
1 gallon of fuel per minute 15,380 lbs and 30 gallons of oil for the
crankcase and four zeinth carberators = fun :) and please check out my
other videos of cold starts i just added along with the others thanks!!!
Runaway Jet Engine
Always remember to check your tie-downs!
Bristol / Rolls-Royce Viper Engine.
59' Hayes first start in 10yrs
This is my 59' Hayes Clipper 220 Cummins first start in 10 plus years. Put
a couple batteries in it and she whirled right over and fired.
Detroit Diesel 2-stroke V8 start and run (idle)
Detroit Diesel (GM) 8V71TT start. It was sitting in a partially sunken
boat, and have'nt been started for a while.
It had been cranking for a while before I got there with the camera.
Unknown power, and unknown year produced.